Skip to menu
Skip to content
Rotary Lobe Positive Displacement Sludge Pumps for Pumping Sludge
1-888-997-PUMP (7867)
Quotes: Contact Engineering
General Info: Contact LobePro
 

Operating Principle

How Rotary Lobe Pumps Work

Operating Principle

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

LobePro rotary pumps are positive displacement pumps. A positive displacement pump operates by trapping a fixed amount of fluid from an intake pipe and then forcing (displacing) that trapped volume into a discharge pipe.

LobePro pumps utilize intermeshing 4-wing helical lobes mounted on parallel shafts. The shafts are rotated by gears with a maintenance friendly design (no complicated timing gears to worry about).

As the lobes un-mesh on the intake side, they create a cavity with an expanding volume. Your sludge or slurry flows into the cavity and is trapped by the lobes as they rotate.

The sludge or slurry then travels around the interior of the casing in the void between the lobes and the housing segments. The pumped material does not pass between the lobes.

As the lobes begin to mesh on the discharge side, the lobes force the sludge or slurry through the outlet port under pressure. The capacity of material being pumped can be changed by varying speed of the pump.

The LobePro pump model numbers correspond to the volume they pump per 100 revolutions at low pressures. For instance, the M100 can pump 100 GPM per 100 revolutions or 1 gallon per RPM. As pressure is added, the output is reduced because of slip. Expected output for each pump can be found in the Pump Spec Sheets.

With "S" shaped flanges, LobePro pumps are able to self-prime from the residual fluid in the piping.

LobePro Images